The advice is to use a profile that is the same height as the thickness of the tile. As the profile has perforated sections, it is dipped into the adhesive without adding any thickness beneath the tile. Particularly with Bordertec drip-edge profiles, it is important – if in doubt – to ensure that the profile is flush with, or possibly slightly lower than, the floor level. This prevents water from pooling and ensures it drains away as intended. Interested in other case studies? Click here

Movement joints are superficial joints (at the floor level), placed in correspondence with the underlying substrate. The superficial joint must be realized in exact correspondence with the joint of the substrate, even just a 5cm difference between the 2 joints can cause tile breakage or tenting (you may hear a “popping” sound). We recommend placing movement joints around areas with a maximum side length of 4 meters (16m2).

No, when the membrane is used as a decoupling system – to prevent tiles from cracking when laying ‘large-format’ tiles, or when the existing subfloor is not perfectly level, or where particular stresses are anticipated – it is sufficient, before laying the tiles, to cover the entire surface with the membrane, placing the sheets side by side (without overlapping them).

However, when Floortec is also used as a secondary waterproofing layer (to protect the screed), the joints must be sealed with the Foiltec waterproofing tape, taking care to apply the adhesive in a full-bed layer over the membrane joints, pressing the tape down carefully and overlapping it with Floortec by at least 5cm. The same procedure must be carried out along the entire perimeter to seal the joints between the floor and the wall cladding, bonding half of the strip to the membrane and the other half to the wall. When used in combination with Bordertec drip-edge profiles, position Floortec against the cut edge of the profile and then seal the cut edge to the membrane using the waterproofing strip, bonding half of it to the membrane and half to the profile.